Cheap Ethnic Eatz · Archive · January 2013
How to Make Romano at Home
Month six: a hard Italian grating cheese made with thermophilic culture and lipase, a new press, and a long wait.
January's Cheesepalooza challenge offered a choice of Parmesan, Asiago, Romano or Brick. On spaghetti nights in Evelyne's childhood her mother set out grated Parmesan and Romano, the fake stuff in a shaker, and she always went heavier on the Romano for its sharper bite. So Romano it was.
This was the month of upgrades. A proper cheese press from a supply shop starts at about 150 dollars, so she found a homemade one on eBay for 50 dollars delivered. It was not perfect, but it worked, and it earned a "YAY" in the post. A friend's father, who had tried cheese-making for two months and moved on to another hobby, then gave her all his equipment: a book, ingredients, a cheese ladle, wax, and butter muslin. That last item changed everything. Butter muslin is so finely woven that one layer is usually enough, and you can wash it and reuse it. She never used cheesecloth again.
A pattern she was starting to notice
This recipe was a struggle. Her gut feeling, stated plainly as a hunch rather than a fact, was that cheeses made with mesophilic culture and buttermilk always worked for her, while anything using citric acid or thermophilic culture was where failure lurked. Those two kept turning her milk into ricotta. Here she added the rennet and went straight to the expected final curd. Technically, she admitted, it might not be a Romano at the end, but it was a cheese.
At the time of writing it was almost two months old and about to be rubbed with olive oil. No mould so far. She loved smelling the flavour develop, because every cheese starts as a flavourless curd and ageing is where the chemistry happens. She still had at least three months to wait before tasting. Torture, she said.
Romano Cheese
Ingredients
- 2 litres skimmed milk
- 2 litres whole milk
- 150g (5 oz) thermophilic starter culture
- 1/4 teaspoon lipase powder, dissolved in 1/4 cup cool water for 30 minutes
- 1/4 teaspoon calcium chloride, dissolved in 1/4 cup cool water
- 1/4 teaspoon rennet, dissolved in 1/4 cup cool water
- For the brine: 2 litres water, 450g cheese salt, 1/2 tablespoon calcium chloride, 1/2 teaspoon vinegar
Method
- Heat the milk to 32C (90F). Add the culture and let the milk ripen at 32C for 60 minutes. At the 40-minute mark stir in the rehydrated lipase.
- When the hour is up, stir in the diluted calcium chloride for 30 seconds, then the diluted rennet with a gentle up-and-down motion for one minute. Leave the milk still for 30 minutes until you get a clean break.
- Cut the curd into small cubes, about 6mm. Heat the curds to 47C (116F) over 45 minutes, raising the temperature by about a degree every five minutes and watching it constantly.
- Hold the curds at 47C for 30 minutes, or until a handful keeps its shape when squeezed. Drain off the whey.
- Line a 500g cheese mould with butter muslin or cheesecloth and fill it with the curds. Press at 5 pounds for 15 minutes. Remove, peel off the cloth, turn the cheese, re-dress it and press at 10 pounds for 30 minutes. Repeat at 20 pounds for two hours, then again at 40 pounds for 12 hours.
- Make the brine by dissolving the salt in the water, then mixing in the calcium chloride and vinegar. Soak the cheese in it for six hours in the fridge, flipping every 90 minutes. Pat dry.
- Age at 13C (55F) and 85% humidity, turning it often and wiping away any mould with a cloth dampened in vinegar or salt water. After two months rub lightly with olive oil to stop the rind drying out, then age for another three to ten months.
Note: If using lipase with cow's milk, use lower-fat milk: half skimmed, half whole gives a starting fat content of about 2.2%. Without lipase, full-fat milk is fine.
The recipe
As usual she combined two recipes, because she uses calcium chloride with shop milk and not every recipe lists it. If you use lipase, as she did, use half whole milk and half skimmed to bring the fat down.
About the brine
The brine recipe came from another cheese-making site. Once you are done brining, pour it into a thick freezer bag and keep it in the freezer until next time. It will not freeze solid, so stand it somewhere it stays upright.
More from Making Cheese at Home
The Cheesepalooza project. Part of the Cheap Ethnic Eatz archive kept by HomeCooks.
Part of the Cheap Ethnic Eatz archive (2009-2015), rebuilt so a good post still leads somewhere. Explore HomeCooks meals
